H&R STABILIZERS FOR THE VW T4

Modern times at VW

With the launch of the T4, the era of rear-engine and rear-wheel drive ended for the VW Bus (/Transporter) after 40 years.

In 1990, there was a switch to front-engine and front-wheel drive (optionally all-wheel drive), allowing for a continuous cargo area.

 

The torsion bar suspension invented by Ferdinand Porsche, which had already proven itself in numerous models such as the Bus Type 2 (T1 and T2), was also used here on the front axle.

H&R is now producing the 27 and 28 mm diameter anti-roll bars (for front and rear axle) available again for vehicles manufactured from January 1996 onwards.

For high roof vehicles, campers etc. a rear axle stabilizer with 30 mm diameter is also available.

Available for order

Part no.: 33904-1
H&R stabilizer Ø27 mm, only for front axle
(from year of construction 01/1996)
The installation is done with the original droplinks of the Ø23,5 mm standard stabilizer (not included). The rubbers needed for the installation are included.

Part no.: 33904-2
H&R stabilizer Ø27 mm, for front axle
(from year of construction 01/1996)
The installation is done with the original droplinks of the Ø23,5 mm standard stabilizer (not included). The bearing rubbers needed for the installation are included.

H&R stabilizer Ø28 mm, for rear axle
(from year of construction 01/1996)
The rubbers required for the installation are included.
Attention: For models without standard rear axle stabilizer, the original bushings and clamps blocks are additionally required for installation (not included).

Part no.: 33904-3
H&R stabilizer Ø27 mm, for front axle
(from year of construction 01/1996)
The installation is done with the original droplinks of the Ø23,5 mm standard stabilizer (not included). The bearing rubbers needed for the installation are included.

H&R stabilizer Ø30 mm, for rear axle
(from year of construction 01/1996) especially for high roof vehicles, campers etc.
without parts approval.
The rubbers required for the installation are included.
Attention: For models without standard rear axle stabilizer, the original bushings and clamps blocks are additionally required for installation (not included).

If you have any further questions, please contact us at the following mail address:
[email protected]